A common worry about refurbished servers is the electricity bill. The honest answer is that a refurbished server uses exactly as much power as the same model did when it was new. What matters is the generation and the configuration: an older server doing the same job may use more power than a newer one, and extra drives, CPUs and power supplies all add to the total.
What drives server power consumption
| Factor | Effect on power | How to reduce it |
|---|---|---|
| Server generation | Newer platforms usually do more work per watt | Choose Dell 14th generation or HPE Gen10 where the budget allows |
| Processors | Higher-TDP and dual CPUs draw more | Pick a CPU sized to the workload; one socket may be enough |
| Hard drives | Each spinning drive adds a few watts | Use fewer, larger drives or SSDs |
| Memory | More DIMMs add some power | Install what you need, with room to grow |
| Power supply efficiency | Efficient PSUs waste less as heat | Use the PSU rating your server supports and size PSUs sensibly |
| Workload | Busy servers draw more than idle ones | Consolidate workloads with virtualisation |

How to estimate the running cost
Use this formula: average watts × 24 hours × 30 days ÷ 1 000 = kWh per month. Multiply by your electricity tariff.
| Average draw | kWh per month | Cost per month at an example tariff of R3/kWh |
|---|---|---|
| 100 W | 72 kWh | R216 |
| 150 W | 108 kWh | R324 |
| 250 W | 180 kWh | R540 |
Power supply rating is not power use
A server with two 750 W power supplies does not use 1 500 W. The rating is the maximum each supply can deliver, and the second supply is usually there for redundancy. Typical draw is far lower and depends on configuration and load.
Refurbished vs new: the full picture
A new server may use less power for the same work, but it costs much more up front. For many small businesses, the price difference pays for years of electricity. Read our comparison of refurbished vs new servers, and our guide to sustainable server management for ways to cut energy use.
Frequently asked questions
Do refurbished servers use more electricity?
No more than the same model when new. Older generations can use more power for the same work than newer ones, so the generation matters more than being refurbished.
How much power does a server use?
It varies widely with model, CPUs, drives and load. Check the real figure in iDRAC or iLO rather than relying on the power supply rating.
How do I reduce server power consumption?
Choose a newer generation, size the CPU to the workload, use fewer or solid-state drives, consolidate with virtualisation, and keep the server cool.
What size UPS do I need for a server?
Size it for the actual peak draw of the server and network equipment, with headroom, and for the runtime you need to shut down cleanly.
Want an efficient server? Dell PowerEdge 14th gen and HPE ProLiant Gen10 models offer good performance per watt, or ask our team.


